Status Led; Group Control Unit And Master Channel (All) - weinor BiEasy 15M Bedienungsanleitung

Icons in the position fi eld
Intermediate position reached
(roller shutter, awning; venetian blind)
Ventilation position, fabric tautening or
tilting position reached
(roller shutter, awning; venetian blind)
STOP status
Tab. 5 Icons in the position fi eld of the display
Icons in the operating mode fi eld
Manual mode of receiver
Automatic mode of receiver
Tab. 6 Icons in the operating mode of the display fi eld

4.4.2 Status LED

A radio signal is displayed by the illumination of the status
display (LED ring around the STOP key).
The status LED can display different colours:
Status display (status LED) and its meaning
orange
fl ashing
Ⓒ weinor GmbH & Co. KG
20 | EN
Channel not yet programmed
to a receiver
Status display (status LED) and its meaning
orange
fast fl ashing
orange, then green
orange, the red fl ashing
red and green
2 x alternately, then red
Tab. 7 Status displays and their meaning
The transmission power and radio range are reduced as
the battery power decreases (reduced battery capacity).
If the status LED does not light up when a key is pressed,
the batteries must be replaced (see Chapter 4.6, Replacing
batteries).

4.4.3 Group control unit and master channel (All)

A group refers to the control of several receivers (channels)
at the same time. The selected group is controlled by a tra-
vel command.
With the MultiTel 2 individual channels can be combined
into fi ve different groups for group control. The master
channel ("All" channel selection in the display) controls
all available channels simultaneously.
Ⓒ weinor GmbH & Co. KG
Channel in programming
mode, previously
programmed receivers
cannot be operated. Lights
continuously every three
seconds in group mode
Receiver has received the
signal sent by the hand-held
transmitter and responded
Receiver has not received
the signal sent by the hand-
held transmitter
Channel deleted in receiver
and transmitter
EN | 21