Requirements For Personnel; Safety Instructions For The Technical Status; Safety Instructions For Operation; Product Description - weinor BiEasy 15M Bedienungsanleitung

2.4

Requirements for personnel

 Every person authorised to work with the device must
have read and understood the complete operating
instructions before carrying out the appointed work.
This is also applicable if the person has already worked
or had training with a similar device.
 All work on the device is conducted by trained
technicians who have been authorised and trained in
safe operation. All operatives must be familiarised with
the dangers of working with the device before starting
any work with it.
 All persons are permitted to conduct only work in
accordance with their qualifi cations. The area of
responsibility of the person must be clearly defi ned.
 No person who is appointed to work with the device
may have any physical restrictions that could temporarily
or permanently reduce attention span and judgement
(e.g. fatigue).
 Minors or persons under the infl uence of alcohol, drugs
or medications are not permitted to use the device or
conduct any assembly, disassembly or cleaning work.
2.5

Safety instructions for the technical status

 The operator is required to use the device only if it is
good and safe condition. The technical status must
conform to the legal requirements at all times.
 If hazards to persons or changes in operating
characteristics are detected, the device must be taken
out of service immediately and reported to the operator
of the system.
Ⓒ weinor GmbH & Co. KG
10 | EN
 The device must not be modifi ed, attached or converted
in any way without approval by the manufacturer.
2.6

Safety instructions for operation

 The operator of the device is required to ensure
that the device is in safe operating condition before
commissioning.
 This is also required at regular intervals to be
defi ned by the operator during the life of the device.
The operator is responsible for inspections before
starting operation.
3

Product description

3.1

General information

The device is a multichannel radio hand-held transmitter.
It can be used exclusively for bidirectional data
communications (compatible with the weinor weitronic
program).
It is used to control roller shutters, venetian blinds and
sunshades, for switching electrical lighting equipment and
electric heaters.
Ⓒ weinor GmbH & Co. KG
EN | 11