Joystick (Multidirectional Key); Selection Button - weinor BiEasy 15M Bedienungsanleitung

4.4.4 Joystick (multidirectional key)

The joystick (4-way key) is the master control unit for
navigating in the display menus. You can use it to select
any of 15 channels by pressing "down" or "up". Only the
programmed channels are displayed in the operating mode.
individual channel (1)
individual channel (15)
Fig. 3 Navigation in channels, groups, master channel
If multiple single channels are allocated to different groups,
the joystick can be used to select up to fi ve confi gurable
group control units simply by moving it to the side.
Channels are allocated to a group with the "Administration"
menu (see menu structure in "Menu mode", Chapter 4.5).
There is an additional channel for the master channel,
to which all individual channels are assigned. The master
channel is selected by moving the joystick slightly to the
side.

4.4.5 Selection button

Press the selection key briefl y to query the current
automatic status and the receiver position of the
programmed receiver and to update on the hand-held
transmitter.
Ⓒ weinor GmbH & Co. KG
22 | EN
master channel
group channel (1)
group channel (5)
After pressing the key briefl y, all channels, including
channels that have not been programmed yet, can be
selected with the joystick for 30 seconds; after 30 seconds
only the programmed channels are visible.
Press the selection key for a longer time (longer than
1 second) to switch the operating mode of the channel
(between "Auto" and "Manual").
"Manual" operating mode:
The operating mode indicator lights up red and the
operating mode in the display switches between "manual"
and "automatic".
• The receiver now carries out manual travel commands
only and does not respond to automatic travel
commands.
Important:
All automatic functions are disabled in the receivers, the
receiver does not respond to automatic timer commands
and shading commands from programmed sensors.
Exception:
Alarm movements are a result of reported alarms of
corresponding sensors (e.g. wind and rain sensors) are still
executed.
"Automatic" operating mode:
The operating mode indicator shows green and the
operating mode display switches to "Auto".
• The receiver now executes automatic and manual travel
commands.
Important:
Switching the operating mode in the master channel
changes the "Auto" or "Manual" operating mode for all
individual channels.
Ⓒ weinor GmbH & Co. KG
EN | 23