Intended Use; Predictable Misuse; Warranty And Liability; Manufacturer's Customer Service - weinor BiEasy 15M Bedienungsanleitung

In addition to the safety instructions in the operating
instructions the regulations for accident prevention,
environmental protection and occupational health and
safety applicable at the place of use must be observed
and complied with. Regulations and standards for risk
assessment can be found in the EC declaration of
conformity.
1.3

Intended use

The device is intended for use in the fi eld of building
technology (for controlling electrically operated roller
shutters, awnings, venetian blinds, roller blinds, electric
lighting and electric heaters). It is a multichannel radio
hand-held transmitter. Any other uses must be discussed
beforehand with the manufacturer, weinor GmbH & Co. KG
(see Chapter 8, Address).
The operator will be solely responsible for any damage
arising from use of the device that is not in conformity with
the intended use. The manufacturer does not accept any
liability for personal injury and property damage caused
by misuse or process errors, improper operation and
commissioning.
Conformity with the intended use as specifi ed in the
operating instructions is the only guarantee of safe and
error-free use and the operational safety of the device.
1.4

Predictable misuse

Predictable misuse is considered use that is not
in accordance with the purposes approved by the
manufacturer, weinor GmbH & Co. KG (for address
see Chapter 8, Address).
Ⓒ weinor GmbH & Co. KG
6 | EN
1.5

Warranty and liability

The General Terms of Supply and Delivery of the
manufacturer, weinor GmbH & Co. KG (for address
see Chapter 8, Address) are applicable. The terms and
conditions of sale and delivery are a component of the sales
documentation and are handed over to the operator on
delivery. Liability claims in the event of personal injury and
property damage will not be accepted if they are the result
of one or more of the following causes:
• Device opened by the customer (breakage of seal)
• Improper use of the device
• Incorrect installation, commissioning or operation of
the device
• Structural modifi cations to the device without approval
in writing by the manufacturer
• Operation of the device with incorrectly installed
connections, defective safety equipment or incorrectly
installed safety and protective equipment
• Non-observance of the occupational health and safety
regulations and instructions in the operating instructions
• Exceeding the specifi ed technical data
1.6

Manufacturer's customer service

The device must be repaired by the manufacturer only
if it needs repair. See Chapter 8 "Address" for where
to send the device to customer service for repair.
If you did not purchase the device directly from weinor,
contact the supplier of the device.
Have the serial number ready for the customer service.
It is on the name plate on the back of the device.
Ⓒ weinor GmbH & Co. KG
EN | 7