Programming Additional Transmitters; Synchronous Programming Mode; Stopping Programming Mode In The Transmitter - weinor BiEasy 5M Original Bedienungsanleitung

Explanation of functions

Programming additional transmitters

Note
If several receivers are connected to the same supply
line, then all are simultaneously in programming mode for
approximately 5 minutes after the mains power is switched on.
If the P button on the transmitter is now pressed, all the
receivers start programming mode at the same time (up/down
movements). Randomly different intervals between up/down
movements cause the receivers to become offset against one
another. The longer programming is delayed, the greater the
offset will be.
The short up/down movements can be stopped by pressing
the STOP button briefl y on a transmitter which has already
been programmed. The programming mode in the receiver is
interrupted.
The transmitter can now be assigned without having to
disconnect individual receivers. If the blind moves in the wrong
direction, delete the transmitter and program it again.
(→ see Deletion of transmitter)
For programming additional transmitters to one receiver:
1. Press the UP, DOWN buttons and the programming button P
(rear of unit) simultaneously (for 3 seconds) on a transmitter
which has already been programmed to the receiver. The status
display lights briefl y. The receiver is now in programming mode.
2. Press the programming button P on the transmitter to be
programmed until the status display lights briefl y. The receiver is
now in programming mode (up/down movements).
3. Press the UP button as soon as the blind starts moving in Open
direction (within 1 second at the most). The status display lights
briefl y. The blind stops briefl y, starts moving again and then
moves downwards.
4. Immediately (within no more than 1 second) after down travel
has started, press the DOWN button. The status display lights
briefl y. The blind stops. The transmitter channel is programmed.
12 | EN © weinor GmbH & Co. KG
Explanation of functions
If more than 10 bidirectional receivers are being programmed at the
same time, the transmitter channel in programming mode switches
to group mode. The group mode is indicated by fast fl ashing with
pauses.
Programming in group mode is completed after a 2-minute pause or
pressing the STOP button for 6 seconds.
Note
A jogging mode for Venetian blinds for quickly reaching
receivers which are further away is not possible in a transmitter
channel with more than 10 programmed receivers.

Synchronous programming mode

For programming additional receivers to one transmitter at the same
time:
1. Press the DOWN button and the P programming button (rear of
unit) simultaneously (for 3 seconds) on a transmitter which has
already been programmed to the receivers. The status display
fl ashes. The receivers are now in programming mode.
2. Press the programming button P on the transmitter to be
programmed until the status display lights briefl y. The receivers
are now in programming mode (up/down movements).
3. Press the UP button as soon as the blind starts moving in Open
direction (within no more than 1 second). The status display
lights briefl y. The blinds stop briefl y, start moving again, stop and
then move downwards.
4. Immediately (within no more than 1 second) after down travel
has started, press the DOWN button. The status display lights
briefl y. The blinds stop moving. The transmitter channel is
programmed.

Stopping programming mode in the transmitter

Press the STOP button for at least 6 seconds until the status display
lights orange.
© weinor GmbH & Co. KG EN | 13