Cleaning The Cooling Unit - Unit Cover Removal - Pfannenberg DTS 6801 Betriebsanleitung

GB
5.2

Cleaning the cooling unit - Unit cover removal

Item Designation
1 Fastening screws
4 Bottom plate slot
Requirement
- The cooling unit is de-energized
Procedure
 Remove the fastening screws (1).
 Tilt the unit cover (5) forward 20° (2).
 Disconnect the earthing cable and connecting cables from the display or operating unit (inside) (3).
 Raise the unit cover about 15 mm and pull it out of the slots in the bottom plate (4).

The unit cover is removed.
Operating Manual DTS and DTI 6801 Standard Controller (SC) 086100009 © Pfannenberg GmbH
1
5
Figure 18 – Unit cover removal
Item Designation
2 Tilting angle 20°
5 Unit cover
1
2
3
4
Item
3
Designation
Display or operating unit
Page 31 / 38