Automatic Answering - switel DF 831 Bedienungsanleitung

Preparing the Telephone
Inserting the battery pack
Press the locking button on the
battery compartment cover and,
at the same time, slide the cover
down. Remove the battery com-
partment cover. Connect the
plug on the battery pack in the
socket in the battery compart-
ment. Insert the battery pack in
the battery compartment. Only
use the battery pack supplied.
Pay attention that the cable is
not jammed. Replace the cover
back on the battery compartment
and slide it upwards until the lock-
ing button snaps into place.
Charging the battery pack
Before the handset is used for the first time, insert it in the
base/charging station for at least 15 hours.
When the handset is inserted in the base/charging station properly,
you will hear an acoustic confirmation signal and the charge control
lamp lights up. The handset warms up during the charging process.
This is normal and does not represent a risk. Do not charge the
handset with charging units from other manufacturers. The current
battery charge status is indicated in the display:
Full
Setting the time and date on the handset
The time and date are set via the menu. Refer to Page 87 for the se-
quence of menu option selections.
78
63
2/3 Full Low

Automatic answering

If this function is activated, an incoming call is taken when the handset
is removed from the base station. The automatic answering function is
activated and deactivated using the menu. Refer to Page 87 for the
sequence of menu option selections.
Private branch exchanges
The information on Page 85 explains how to install your telephone in
a private branch exchange.
Low−radiation operation (ECO mode)
The level of radiation is considerably lower than that of standard
DECT cordless telephones when in Standby mode (when the handset
is in the base station).
Empty