Putting The Telephone Into Operation; Checking The Package Contents; Wall Installation - switel TC40 Bedienungsanleitung

2 Putting the Telephone into Operation

Safety information
Attention: It is essential to read the Safety Information in
Chapter 1 before starting up.

Checking the package contents

The package contains:
Content
Telephone
Premium receiver
Helix cable for receiver
Telephone connection cable
Wall installation bracket
Operating instructions
Connecting the base unit
Connect the telephone as illustrated in the diagram. Only use the
telephone connection line supplied because the equipment may not
function if another telephone connection line is used.
Telephone line socket
14
TC 40
1
1
1
1
1
1
Receiver connection
Putting the Telephone into Operation

Wall installation

The telephone can also be installed on a wall. You require two screws in
order to fix the telephone on a wall.
Feed the guide tabs (1) on the wall−mounting bracket (2) in the slots (3) on
the rear side of the telephone. Slide the wall bracket (2) 10 mm upwards
until it audibly snaps into place.
Warning: Ensure that there are no cables or pipes etc. in the
wall where you want to drill the holes.
Drill two holes whose distance apart corresponds to the bracket to be
used, insert the screws and allow them to project 5 mm from the wall.
Position the telephone on the bracket, fit the screws in the slots and slide
the telephone downwards a little.
Turn the receiver hook (4) in the receiver cradle 180° so that the receiver
can be hooked in.
3
3
1
4
4
2
4
4
4
41