Putting The Telephone Into Operation - switel TC49S Bedienungsanleitung

Putting the Telephone into Operation

2 Putting the Telephone into Operation
Safety information
Checking the contents of the package
The package contains:
− a telephone (base unit)
− a receiver
− a helix cable
− a telephone connection cable
Connecting the receiver
Use the helix cable to connect the receiver to the telephone base unit. The helix cable has two
identical connectors; plug one end of the cable into the socket at the bottom end of the receiver,
plug the other end of the cable into the connection socket on the left−hand side of the telephone
base unit. The plugs engage in the sockets audibly.
Inserting the batteries
The batteries are required for the display indicators and other telephone functions.
The battery compartment is located on the underside of the telephone. Open the battery compart-
ment using a pointed tool (e.g. ball−point pen) and insert four AA 1.5V alkaline batteries.
Pay attention to correct polarity of the batteries: Slide the minus pole of the battery (flat end)
against the coiled spring and then press the plus pole down. The correct position of the batteries is
also imprinted on the base of the battery compartment.
Only use batteries of the specified type.
Close the battery compartment properly; the cover locks audibly in place.
The batteries must be replaced by new ones when the battery icon
display.
Date and time
The date and time will be set automatically with the first CLIP call received.
Setting the display contrast
If you need to change the display contrast, press the y and z buttons simultaneously for
4 seconds. The message LCD CONTRAST appears in the display. Use the y or z
buttons to adjust the contrast (1−5) and confirm the selection by pressing the – button.
48
Caution: It is essential to read the Safety Information in Chapter 1 before starting up.
20
Prior to inserting or replacing the batteries, ensure that the telephone is disconnected from
the telephone network.
The telephone's memory content is retained for 3 minutes when no batteries are installed.
Condition: Your network provider supports this feature.
− four batteries (AA 1.5V alkaline)
− a wall mounting bracket
− an operating manual
appears in the telephone