Switching On; Selecting Operating Mode - Sentiotec WC4-B-H Montage- Und Gebrauchsanweisung

Instructions for use for the user p. 18/42

4.3. Switching on

The control unit must be connected to the power supply.
The left symbol illuminates constantly. If the time symbol also illumi-
8 a
nates, the automatic switch-on or pre-set time (programming see Point 5 of
these operating instructions) is active and the control unit will switch on after
the displayed time.
Pressing the key switches the control unit on and the cabin light connected
4
to the control unit starts to illuminate. The operating mode (see Point 4.4. of
these operating instructions) must then be selected.

4.4. Selecting operating mode

After switching on (see Point 4.3 of this manual) select one of the following modes
with the and keys:
5 6
„FIN" = Finnish (dry) operation
Confirm your selection with . The temperature symbol illuminates. The
4 9
sauna control unit now starts with the configurations last executed or with the
standard values (factory settings) and begins to heat with the last settings of
the respective operating mode.
WORLD OF WELLNESS