Preparing For The Application; Carrying Out The Skin Sensitivity Test - Beurer SatinSkin Pro IPL7500 Gebrauchsanweisung

The device has a built-in skin contact sensor to protect the eyes. The sensor was developed
so that no light pulses can be emitted when the device is held in the air. The safety switch
is only activated when the skin contact sensor is in full contact with the skin.

5. Preparing for the application

Before you can start the application, you must fi rst complete the following:
1. Using the hair and skin colour chart (on the back page of these instructions for use),
check which intensity level is suitable for you. An "x" in the table indicates that the
device is not suitable for you to use.
2. Before each application, shave the body parts that you wish to treat.
Do not use a hair removal cream instead of a razor.
3. Ensure that the skin areas to be treated are shaved, dry and clean
(free from any residue such as powder, cream, make-up or deo-
dorant).
WARNING
Do not clean the skin with fl ammable liquids such as alcohol or acetone shortly before us-
ing the device.
4. Clean the light area and skin contact sensor using a dry, lint-
free cloth.
5. Perform a skin sensitivity test on every body part that you would
like to treat 48 hours prior to the full treatment.

5.1 Carrying out the skin sensitivity test

1. Insert the device plug into the device and insert the mains plug into the mains socket.
The indicator lamp begins to fl ash green (stand-by).
33