Special Instructions For Facial Treatments - Beurer SatinSkin Pro IPL7500 Gebrauchsanweisung

Application method 1 "fl ash-glide function":
Hold down the trigger button. The device emits a series of consecu-
tive light pulses so long as the skin contact sensor is in full contact
with the skin. Move the device onto the next area after each light
pulse. Continue to hold the light area down on the skin. This mode
is suitable for treating larger areas in particular, for example the legs.
Application method 2 "releasing individual fl ashes":
Release the trigger button after each light pulse. For the next light
pulse, position the device on the area directly next to the area that has just been treated.
Ensure that the light area and skin contact sensor come into full contact with the skin. This
mode guarantees precise treatment, e.g. for knees or ankles.
Note
If the device does not emit any light pulses and the indicator lamp is orange, this indicates
that there is not enough contact between the skin sensor and the skin.
If the device does not emit any light pulses and the indicator lamp is red, this indicates that
the skin surface to be treated is too dark.
Note
Allow the device to cool for a few minutes if it seems too hot for you. You can continue your
treatment as normal after a short cooling period.

6.2 Special instructions for facial treatments

WARNING
• Men must not use this device on the face.
• Do not use the device on the face at an energy level higher than 2. Do not use the device
on the face above the cheekbones or on the eyes, eyebrows or eyelashes, as this could
result in severe damage to the eyes. Do not use the device on mucous membranes in
the nose or throat area.
• The skin on your face is very sensitive and requires special care. Observe all warning and
safety notes in these instructions for use to prevent adverse consequences. We recom-
mend that you fi rst perform a treatment on your body and get to know the device before
performing facial treatment. The device can be used to treat all areas of the face below
the cheekbones, such as the upper lip, cheeks, jaw, chin and neck.
1. You must carry out a skin sensitivity test 48 hours before treatment (see section 5.1). The
skin sensitivity test should be performed on an area without hair, such as below the ear
or on the side of the neck, to determine the suitable energy level.
36