Electrical Connection; Removing The Transport Support; Rear Spacers - AEG S83800KMW0 Benutzerinformation

36 www.aeg.com
7.2 Location

7.3 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-

7.4 Removing the transport support

7.5 Rear spacers

3
To ensure best performance, if the appli-
50 mm
ance is positioned below an overhang-
ing wall unit, the minimum distance be-
tween the top of the cabinet and the
wall unit must be at least 40 mm . Ideally,
however, the appliance should not be
positioned below overhanging wall units.
The ventilation space can be:
• directly above the appliance
• behind and above the top cupboard.
In this case, the space behind the top
cupboard must be at least 50 mm
deep.
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
Your appliance is equipped with trans-
port support to secure the door during
transportation.
To remove them do these steps:
• Open the door.
• Remove the transport support from
the door sides.
• Remove the transport support from
the lower hinge (some models).
2
Install the spacers provided within the
accessory bag as shown in the figure.
Install the spacers on the back side of
the panel.
Some models are fitted with a si-
lencing pad under the cabinet.
Do not remove this pad.