Periods Of Non-Operation; Cleaning The Ventilation Grille - AEG S83800KMW0 Benutzerinformation

32 www.aeg.com
the performance of the appliance and
save energy consumption.
Take care of not to damage the
cooling system.
When moving the cabinet, lift it
by the front edge to avoid
scratching the floor.
Many proprietary kitchen surface clean-
ers contain chemicals that can attack/
damage the plastics used in this appli-
ance. For this reason use a soft cloth
rinsed in warm water and neutral soap
emulsion for cleaning external surfaces.
Do not use detergents or abra-
sive paste as these will damage
the paint, or stainless steel anti
finger print coating.
After cleaning, reconnect the equipment
to the mains supply.
5.2 Replacing the Clean Air
Control filter
To get the best performance replace the
Clean Air Control filter once every year.

5.4 Cleaning the ventilation grille

New active filters can be purchased from
your local dealer.
Refer to "Installation of the Clean Air
Control filter" for instructions.

5.3 Periods of non-operation

When the appliance is not in use for
long periods, take the following precau-
tions:
1. disconnect the appliance from elec-
tricity supply
2. remove all food
3. defrost and clean the appliance and
all accessories
4. leave the door/doors open to pre-
vent unpleasant smells.
If the cabinet will be kept on, ask
somebody to check it once in a
while to prevent the food inside
from spoiling in case of a power
failure.
The ventilation grille can be removed for
washing.
Make sure the door is open and then:
• Loosen the upper edge of the grille by
pulling outward/downward.
• Pull the grille straight out to complete-
ly remove it.
• Vacuum clean under the cabinet.