Preset Menu - AKG HT 4000 Bedienungsanleitung

3. Having set the desired frequency, push the jog switch briefly. This brings up the following screen:
4a If you want to save the selected frequency, push the jog switch briefly. Your setting will be saved in
memory and the display will change as follows:
4b If you'd rather not save the selected frequency, briefly turn the jog switch to the left or right.
This brings up the following screen:
Push the jog switch briefly. The transmitter will stay tuned to the original frequency and the display will
revert to the following screen:
You can now go on to set the input gain referring to section 3.8 or switch the transmitter to LOCK
mode.
A Preset comprises one or two Groups of carrier frequencies. Group numbers are shown under the
"GRP" label. Carrier frequencies are also called "Subchannels" whose numbers are indicated below the
"CH" label. The spacing between these frequencies is wide enough to prevent any mutual interference
(intermodulation). Presets make it much easier to design a multichannel system. They save time because
you do not need to calculate your own carrier frequencies and help you avoid intermodulation problems.
Each Preset has a one or two-character "NAME" relating to the country where the respective carrier fre-
quencies are allocated (e.g., "AT" for Austria, "US" for the USA, or "UK" for Britain). The Preset names
are sorted alphabetically.
When designing a multichannel system, make sure to use Subchannels within the same Group only.
Using Subchannels of different Presets and/or Groups simultaneously may cause intermodulation.
Some Presets may be approved in more than one country. To check which Frequency Group(s) is (are)
approved in your country, visit www.akgfrequency.at or contact your local regulation authority.
1. To move from the Frequency menu to the Preset menu, turn the jog switch briefly to the right. The dis-
play will change as follows:
3 Setting Up

3.6.2 Preset Menu

Note:
19