Setting Gain Manually; Operating Notes; Status Screens And Setup Menus; Lock Mode - AKG HT 4000 Bedienungsanleitung

3 Setting Up

3.8.2 Setting Gain Manually

4 Operating Notes

4.1 Status Screens and
Setup Menus

4.1.1 LOCK Mode

22
If you want to save the new setting, push the jog switch briefly.
The display will show your new gain setting in dB and the "GAIN" label will be flashing.
• If you'd rather not save your setting, turn the jog switch briefly to the left or right. The display will
change to "Save-n".
- Push the jog switch briefly. The display will revert to the original setting, with the "GAIN" label flash-
ing.
5. To set input gain again, repeat steps 1 through 4 above.
6. To return to LOCK mode, push and hold the jog switch for approx. 1.5 seconds.
1. Turn the jog switch briefly to the left.
The display will indicate the current gain setting in dB.
2. To increase the gain value by 1 dB, turn the jog switch briefly to the right. The readout "25" will be fol-
lowed by "Auto".
To decrease the gain value by 1 dB, turn the jog switch briefly to the left. The readout "00" will be fol-
lowed by "Auto".
3. Push the jog switch briefly.
This brings up the following screen:
• If you want to save the new setting, push the jog switch briefly.
The display will show your new gain setting in dB and the "GAIN" label will be flashing.
• If you'd rather not save your setting, turn the jog switch briefly to the left or right. The display will
change to "Save-n".
- Push the jog switch briefly. The display will revert to the original setting, with the "GAIN" label flash-
ing.
5. To set input gain again, repeat steps 1 through 3 above.
6. To return to LOCK mode, push and hold the jog switch for approx. 1.5 seconds.
In LOCK mode, three status screens are available.
1. To scroll through the status screens in the order shown below, turn the jog switch briefly to the right.
Frequency Screen: Carrier
frequency in MHz, battery
capacity bars. The "MUTE"
label appears if the micro-
phone is muted.
Preset Screen (comes up only
if at least one Preset has been
saved): Carrier frequency as
Subchannel number within a
Frequency Group, battery
capacity bars. If the micro-
phone is ON, the "MUTE"
label is off.