Characteristic Curve Pre-Selectioncharacteristic; Setting The Characteristic Curve - Dimplex Uph 90-25 Montageanleitung Und Bedienungsanleitung

UPH 90-25 - UPH 90-32

8 Characteristic curve pre-selectionCharacteristic

8.1 Types of control
The pump enables 6 pre-set speeds to a set:
 three proportional pressure levels (PP)

8.2 Setting the characteristic curve

Flashes quickly
Flashes quickly
Flashes quickly
Flashes slowly
Flashes slowly
Flashes slowly
Fig. 8.1: Setting the characteristic curve
Press the button on the pump electronics box for 2
seconds
 Pump enters setting mode
 LED starts to flash
The setting changes each time the button is pressed (see
Fig. 8.1 on p. 6)
 LED 1-2 and 3 are permanently on, i.e. the characteristic
curve and type of control can be changed
Flashing mode by pressing the button again
 Flashing quickly = proportional pressure curve
 Flashing slowly = constant pressure curve
If the button is not pressed for 10 seconds
 the setting is applied
 Pump returns to mode operation
Only one LED is permanently on (LED 1, 2 or 3)
 Pump is in the mode operation and runs with the pre-set
characteristic curve
EN-6
 three constant pressure levels (CP)
452115.66.25 FD 9403
PP1
PP2
PP3
CP1
CP2
CP3