Cutting variants for the corner cutter
1. Mitre cuts at slopes
The mitre angle is transferred in 3 steps onto the corner
cutter as follows:
Step 1:
Take the angle from the object by means of the supplied
sliding bevel and fix it at the sliding bevel (fig. 10).
Step 2:
Transfer the taken angle by means of the sliding bevel
onto the sliding bevel (no. 25, fig. 11) of the corner cutter.
Step 3:
Adjust and tension the cutting wire with the aid of the
angle lock lever (no. 24, fig. 11) and the tensioning lock
lever (no. 23, fig. 11).
Fig. 10
Fig. 11
23
24
86
House wall
Foam board
25