Storch ProCut compact Bedienungsanleitung Seite 85

The corner cutter is switched via the on / off switch (no. 29, fig. 7) just the same way as the cutting bow.
WARNING:
Cutting is only possible either by means of the main wire or by means of the corner cutter! If a change from the corner
cutter to the cutting bow is to be performed, press the on / off switch of the cutting bow 2x. If a change back to the
cutting bow is to be performed, press the on / off switch of the cutting bow 2 x. Further information on the cutting wire
can be found under the heading "On / off button with timing and LED".
Parking position for corner cutter
In case the corner cutter is not needed, guide the same together with the sliding shoe (no. 28, fig. 7) at the rear side
into the guide profile for the cutter corner (no. 21, fig. 7).
WARNING:
Please pull the cord of the corner cutter out of the slot at the rear side of the device first.
Fig. 9:
Parking position corner cutter
85