Preface; Application Area; Cleaning And Maintenance; Safety Information - Storch ProCut compact Bedienungsanleitung

Preface

Reading this instruction manual is the basis for operating the compact ProCut multi foam board cut-
ter. Before starting to use the device this instruction manual must be read carefully and in full. If there is
anything you do not understand, contact us immediately. Do not operate the device if you are in any doubt.
By starting to use the device, you confirm that you have read and understood the manual and assume the
responsibility for its operation.
The methods and procedures used for manufacturing and quality monitoring purposes correspond to state of
the art technology.
The device possesses a voltage range which can pose an electrical hazard to humans and animals in the
event of certain unfavourable conditions.
It should only be unscrewed and / or disassembled by authorised personnel. Similarly, maintenance and
repair work should only be conducted by electrical specialists and authorised service centres. The buyer /
user operates the device at their own risk and under their own responsibility.

Application area

This device is intended exclusively for cutting rigid polystyrene foam (styrofoam).
Operation
This device should only be used by an instructed person who is familiar with its operation. Use of suitable work clothing
and protective gloves is recommended (Also refer to the section entitled "Safety precautions").
If the device is going to be used indoors, it should only be operated in areas that are adequately ventilated. The device
operates with low voltage and it should only be used with the connected special transformer.
The device should only be operated with the original cutting wire (d = 0.7 mm). Further information on cut-
ting wire can be found under the heading on / off button with timing and LED.

Cleaning and maintenance

Before starting to use the device all nuts and bolts must be checked and re-tightened if necessary. Wire guide rollers
and pullout elements are to be cleaned and checked for free movement. If it is heavily contaminated (incrustation), the
cutting wire must be replaced.

Safety information

Protect the device from moisture. Outdoor operation in the rain is prohibited. Only use dry utensils when cle-
aning; do not use any cleaning agents that contain solvents.
Smoke is generated during the cutting process. This contains an extremely low amount of styrene, which is
far below the prescribed limit.
The wire gets very hot. If it comes into contact with the skin, it will inevitably result in burns. Use of protec-
tive gloves is recommended. The wire is subjected to mechanical tension (spring force). If the hot wire rup-
tures, it can generate sparks. The use of protective goggles is therefore recommended. The hot wire (ignition
source) represents a fire hazard; make sure any flammable objects are maintained at a safe distance.
If the connecting cable (or plug) is damaged, it must be replaced immediately. Repairs to electrical compo-
nents should only be conducted by an electrician or a STORCH service centre!
75