Storch ProCut compact Bedienungsanleitung Seite 80

Fig. 5:
On / off button with timing and LED
The on / off button is provided with an electronic timing. Unnecessary burning time and danger of injury by hot wire are
avoided. Short and light pressing the button will initiate heating up of the wire, and the cut can be performed. Then,
the wire remains at operating temperature for 60 seconds and subsequently switches off. This is visualised by the red
LED at the switch: LED illuminated = On, LED off = off. If the button is pressed another time within the 60 seconds,
the wire will remain at operating temperature from this moment for 60 seconds again. For repeatedly switching on the
device at cooled down wire it is sufficient to shortly press the on / off switch.
If the wire is to be switched off before expiration of the
timing, press the on / off switch of the respectively other
cutter element.
Example: The wire of the large cutting bow (no. 9, fig. 3)
is to be switched off prematurely, then press the button
of the corner cutter (no. 29, fig. 7). For switching on the
corner cutter, now press its on / off button.
You can switch off firstly the wires being in operation or
secondly change between the two cutting elements in
operation by means of comfort switching, without having
to wait for the timing.
WARNING:
Comfort switching is only possible with inserted corner
cutter.
LED
Button
80