Storch ProCut basic Bedienungsanleitung Seite 38

Accessories:
Left bearing rail, item no. 57 01 05
Clipping support, item no. 57 00 16 (see Fig. 6)
Assembly points for left bearing rail
There are two knurled thumb screws on the rear of the base panel of the ProCut basic/128 (see arrow in Fig. 3) to attach
the left bearing rail. Turn it towards the left up to the stop.
Assembly
Move the left bearing rail over the knurled thumb screws with the slotted assembly panels (Fig. 4) and tighten them.
The left bearing rail is now ready for operation (Fig. 5 and 6).
Fig. 3
Fig. 5
Fig. 4
Fig. 6
38