Maintenance / Repair - i.safe MOBILE IS320.1 Schnellstartanleitung

malware downloaded when using the network or other data-exchange functions of
the device. i.safe MOBILE GmbH cannot be held responsible for any of those claims.
WARNING
i.safe MOBILE GmbH will not assume any liability for damages caused by disregar-
ding any of these advices or by any inappropriate use of the device.

MAINTENANCE / REPAIR

Please note any legal requirements for periodic inspection.
The device itself has no user-serviceable parts. It is recommended to perform
inspections according to the safety regulations and advises.
If there is a problem with the device, please contact your vendor or consult the service
center. If your device is in need of repair, you can either contact the service center or
your vendor.
BATTERY
The battery is not fully charged when the device is purchased, but it contains enough
energy to power on the device. To obtain best battery performance and battery life,
charging cycles.
CHARGING THE BATTERY
Connect the i.safe PROTECTOR to the USB port on the device. Then connect
the i.safe PROTECTOR to the power adapter. After charging, please disconnect
the i.safe PROTECTOR from the power adapter.
BATTERY USE
In actual use the run time of the device varies with the network status, working
environment and usage.
When the power of the battery is lower than normal, the device will prompt you to
saved. If you do not charge for a long time, the device will be powered
WARNING
The device battery may only be charged within a temperature range of +5°C ... +35°C.
Never charge the battery outside this temperature range.
INSTALLATION OF THE SIM CARD
The device has a slot for a micro SIM card. This is located in the battery compartment
under the battery.
WARNING
Do not try to insert or remove the SIM card when any external power supply
is connected, otherwise the SIM card may be damaged.
EN 7