Inserting An Sd Card - Silvercrest SCA 5.00 A2 Bedienungsanleitung Und Serviceinformationen

SilverCrest SCA 5.00 A2
3. Next insert the battery into the camcorder, as shown in figure 2. To do this,
insert its metal contacts first into the battery compartment and then push it
downwards so that it clicks into place. When inserting the rechargeable
battery, make sure that the tag is placed around the battery so that you can
remove the battery easily from the compartment when required.
4. Close the battery compartment by first inserting the bottom part of the cover
and then push it downwards until it clicks into place (see figure 3).

Inserting an SD Card

By using the supplied SD memory card you can increase the camcorder storage
capacity for saving your videos and photos. When a memory card is inserted, all
the recorded contents will be saved onto it. If there is no memory card inserted,
your photos and videos will be saved to the internal memory of the camcorder.
1. Open the memory card compartment (20) by inserting your fingernail below
the cover slot and then carefully pull it upwards and to the front.
2. Then insert the memory card with the metal contacts facing forwards into the
card slot. The label must face towards the right panel of the camcorder
housing. Slide the card fully into the slot opening until the card clicks into
place.
3. Close the memory card compartment by closing the cover and carefully
pressing on it until it clicks into place.
20 - English