Electrical Safety - DeWalt DW341 Bedienungsanleitung

english
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate.
Your D WALT tool is double insulated in
e
accordance with EN 60745; therefore no
earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
e
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm
2
30 m.
When using a cable reel, always unwind the
cable completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
26
; the maximum length is
Fitting and Removing a Saw Blade
(Fig. 2)
The tool-free blade exchange system ensures quick
and easy changing of saw blades.
1. Open the blade holder (G) by fully retracting the
blade latch (E).
2. Insert the saw blade into the blade holder (G)
guiding the back of the blade into the groove of
the guide roller (H).
3. Release the blade latch (E).
4. To remove the saw blade, fully retract the blade
latch and pull the blade out of the holder.
Setting the Bevel Angle (Fig. 3)
The adjustable shoe (I) allows cutting of LH and RH
bevel angles up to 45°. The bevel scale has preset
positions at 0° and 45°.
1. Slacken the screws (K) using the
supplied wrench.
2. Slide the shoe (I) toward the saw blade.
3. Tilt the shoe and set the desired bevel angle
using the scale.
4. Tighten the screws.
Setting the Pendulum Stroke (Fig. 1)
The adjustable pendulum stroke guarantees a
perfect cutting stroke for different materials.
Slide the selector (J) to the desired position referring
to the table below. The selector can be manipulated
during operation.
Pos. Wood Metal
2 Fast cuts -
2 Thick workpieces -
1 Plywood Aluminium
Chipboard Non-ferrous
0 Thin workpieces Sheet metal
Fine cuts
Mounting the Plastic Anti-scratch
Shoe Cover (Fig. 4)
The anti-scratch shoe cover (L) reduces damage to
the surface of (sensitive) workpieces.
Click the cover onto the shoe as shown.
Plastics
PVC
Fibreglass Acrylic
-
-