Jackle dualMIG 250 E Betriebsanleitung Seite 25

Single knob program selection
program welding material
manual ---
1 steel
2 steel
3 steel
4 steel
5 CrNi
6 CrNi
7 Alu
8 Alu
9 steel
10 steel
Single-knob program selection / manual setting
To select the welding material, the weld wire diameter and the shielding gas.
1. Single-knob control (programs 1 to 10):
Upon selection of the welding voltage on the weld-grade switch, optimum wire feed rate will adjust itself
automatically.
2. Manual:
In manual control, the wire feed rate can be adjusted irrespective of the welding voltage.
Operating manual
diameter of wire
--- ---
Ø 0.8 mixed gas Ar82/ CO2 18
Ø 1.0 mixed gas Ar82/ CO2 18
Ø 0.8 CO2
Ø 1.0 CO2
Ø 0.8 mixed gas Ar97,5/ CO2 2,5
Ø 1.0 mixed gas Ar97,5/ CO2 2,5
Ø 1.0 argon
Ø 1.2 argon
Ø 0,8 argon 91/ CO2 5/ O2 4
Ø 1,0 argon 91/ CO2 5/ O2 4
dualMIG 250E
shielding gas
Page 23