ECOVACS winbot 850 Benutzerhandbuch Seite 22

6. Troubleshooting
NO. Malfunction
WINBOT 8 is stuck
in the window corner
and cannot move,
5
be controlled by the
Remote Control, or
be reset by pressing
RESET.
20
EN
Possible Causes
Insufficient suction or Edge
Detection Sensor signal abnormity.
Solutions
A. Press the RESET Button on the
Remote Control.
B. If WINBOT 8 does not Reset, it
must be placed in Manual Override
Mode. Hold the RESET Button on
the Remote Control until the Status
Indicator Light glows a continuous
RED. In Manual Override Mode,
the Direction Control Buttons on the
Remote Control are activated. Use
the Direction Control Buttons to move
WINBOT 8 to a position away from
edges and where you can safely
reach it. Remove WINBOT 8 from the
window and power OFF. Power ON
and restart.
* When using the Manual Override
Mode, do not leave WINBOT 8
attached to the glass.
C. If the problem persists, please
contact Customer Service.