Before First Use - AEG GS45AVB Benutzerinformation

62 www.aeg.com
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold the programme button until the
indicator
indicator
fixed light.
2. Immediately press the programme
button.
The indicator
comes on with fixed light while the
indicator

7. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water softener.
It seems that the appliance is not
working. The washing phase starts only
after this procedure is completed. The
procedure will be repeated periodically.
7.1 The salt container
The salt is used to recharge the resin in
the water softener and to assure good
washing results in the daily use.
flashes and the
stops flashing and
starts to flash.
CAUTION!
Only use salt specifically
designed for dishwashers.
3. Wait until the indicator
The indicator
setting of the acoustic signal. (Factory
setting is with acoustic signal off).
is on with
4. To change the setting, press the
5. Press the on/off button to confirm
How to fill the salt container
1. Turn the cap of the salt container
2. Put 1 litre of water in the salt
3. Fill the salt container with dishwasher
4. Remove the salt around the opening
5. Turn the cap of the salt container
off. The indicator
continues to flash.
shows the current
• Indicator OFF = acoustic
signal OFF.
• Indicator ON = acoustic
signal ON.
programme button.
the setting.
counterclockwise and remove it.
container (Only for the first time).
salt.
of the salt container.
clockwise to close the salt container.
goes