Operation - TESTBOY TV 215N Bedienungsanleitung

Operation

Thank you for purchasing the Testboy
The Testboy ® TV 215N is intended for measuring systems of Category CAT III and for voltages
that do not exceed the reference to earth 600 V (AC or DC).
Operation
Before taking a measurement, allow the appliance to acclimatize.
When using this tong meter, the user must adhere to all usual safety regulations.
|
When using in the vicinity of appliances that cause interference or noise, the display can
|
indicate gross errors.
Only use the appliance as described in these operating instructions, otherwise the protective
|
equipment of the appliance could be impaired.
To prevent damage to the appliance, do not exceed the maximum input values given in the
|
Technical Data.
Pay attention to the function switch and make sure that it is set at the correct position before
|
each measurement.
Particular attention must be paid for tasks on naked cables or busbars.
|
Every inadvertent contact with the conductor can result in an electric shock.
|
Caution when working with voltages of more than 60 V DC or 30 V AC RMS. At such voltages,
|
there is the danger of electric shocks.
Before switching to other functions, the tongs must be removed from the circuit to be tested.
|
During measurements, place the fingers behind the safety ring.
|
To prevent incorrect measurement values: Change the batteries when the
|
appears.
Before each measurement, ensure that the test appliance is fully serviceable. Before using the
|
appliance, test the function using a known, functional source of power.
Test on a known live source within the rated ac/dc voltage and current range of the product,
|
both before and after use to ensure unit is in good working condition.
Use extreme caution when working near naked conductors or bus bars. Individual protective
|
equipment must be used.
Do not use a current sensor if the wear in the jaw end is visible.
|
®
Testboy TV 215N
TV 215N
®
Operation
– symbol
19