Basic Mowing Techniques; Maintenance; Introduction; Maintenance Schedule - Husqvarna LC 141Li Bedienungsanweisung

2. Place the power cord in the power cord holder. For
detailed instruction, see
LC 141C) on page 108 .
3. Position yourself behind the product.
4. Loosen the start inhibitor.
5. To start the motor push the motor brake handle
towards the handlebar.

Introduction

WARNING! Before you do any maintenance
work you must read and understand the
safety chapter.
All LC 141 models
General inspection
116
Power cord holder (model

Maintenance

To stop
1. Stop the motor by releasing the motor brake handle.
2. Disconnect the power cord from the electrical outlet
and then from the product. Pull the plug, not the
cord. Pull the plug straight out.

Basic mowing techniques

• Always mow with a sharp blade for optimal results. A
dull blade gives an uneven cut and the grass
becomes yellow on the surface of the cut.
Additionally a sharp blade consumes less energy
than a dull blade.
• Never mow more than 1/3 of the length of the grass.
This especially applies during dry periods. Mow first
with the cutting height set high. Then check the
result and lower to an appropriate height. If the grass
is really long, drive slowly and mow twice if
necessary.
• Mow in different directions each time in order to
avoid stripes in the lawn.

Maintenance schedule

In the maintenance schedule you can see which parts of
your product that require maintenance, and with which
intervals it should take place. The intervals are
calculated based on daily use of the product, and may
differ depending on the rate of usage.
starting
Before
Weekly Monthly
X
71 - 001 - 03.11.2016