Operation; Introduction; To Set The Mower In Operation Position; To Set The Cutting Height - Husqvarna LC 141Li Bedienungsanweisung

Introduction

WARNING! Before you operate the product,
you must read and understand the safety
chapter.

To set the mower in operation position

If the handle has been folded to transport and storage
To set the product in transport position on
position (see
page 120 ), follow these steps to return the handle to
operating position.
1. Raise handles until lower handle section locks into
place in operating position.
2. Slide the lower knobs up towards the handle until
they stop and a click is heard.
3. Tighten the knobs to secure the handle.
4. Fold up the upper part of the handle and tighten the
knobs on both sides.
112

Operation

To set the cutting height

Note: Do not set the cutting height too low as there is a
risk that the blade might hit ground with unevenness.
The cutting height can be adjusted in 10 different steps.
Move the lever to the back for higher cutting height and
to the front for lower cutting height.

To handle the battery

WARNING! Before handling the battery,
read the section
safety on page 109 in this manual. You
should also read and understand the manual
that accompanies the battery and the battery
charger.
Battery status
The display shows the remaining battery capacity and if
there are any problems with the battery. The battery
capacity is displayed for 5 seconds after the product is
switched off or the battery indicator button is pressed.
The warning symbol on the battery is lit when an error
has occurred. See
Battery and battery charger
Battery on page 118 .
71 - 001 - 03.11.2016