SOLIS CAFFESPRESSO p Bedienungsanleitung Seite 95

Problem
No steam
is generated
No hot water
Milk is not creamy
after texturing
Machine is not
working
Possible Causes
Machine is not turned
on
Water tank is empty
Selector dial is not
in Steam/Hot Water
ã
position
Steam wand is
blocked
Water tank is empty
Not enough steam
Milk isn't cold and
fresh
Safety thermal-cut has
been activated
What to do
Ensure the machine is plugged in and the
POWER-button is illuminated.
Refer to "Filling the Water Tank" (page 73).
ã
Turn the dial to the
Use the pin on the cleaning tool to clear
the opening. If the steam wand remains
blocked remove the tip of the steam
wand using the spanner in the centre of
the cleaning tool. Refer to "Cleaning the
Steam Wand" (page 89).
Refer to "Filling the Water Tank" (page 73).
Steam wand may be blocked. Refer to
"Cleaning the Steam Wand" (page 89).
Use cold fresh milk. Refer to "Texturing
Milk" (page 82).
The safety thermal-cut may have activated
due to the pump overheating. Turn the
machine off and allow to cool for about
30–60 minutes.
position.
95