How To Use; Operation - Silvercrest SSM 175 B2 Bedienungsanleitung

__RP103371_B6.book Seite 6 Montag, 24. November 2014 11:07 11

5. How to use

• Remove all packing material.
• Check to ensure that all parts are pre-
sent and undamaged.
• Clean the device prior to its first
use! (see "Cleaning" on page 7)
• Place the device on a dry, level, non-slip
surface.

6. Operation

DANGER! Risk of electric
shock! Only plug the mains plug|7
into the wall socket when the Smooth-
ie Blender is completely assembled.
DANGER! Risk of injury from
cutting!
~ Under no circumstances should the de-
vice be operated without the blender
jug|6.
~ The blades of the blade assembly|4 are
sharp. Handle it with care.
~ The blades of the blade assembly carry
on rotating after the device has been
switched off. Wait until the blades have
come to a standstill before you remove
the blender jug.
WARNING! In order to prevent damage to
the device, interrupt the blending process
immediately if the blades of the blade as-
sembly|4 rotate with difficulty or not at all.
In this case, pull out the mains plug|7 and
check whether there is an obstruction in the
blender jug|6.
Application area
The Smoothie Blender is intended solely for
blending of whole fruit drinks (smoothies).
6
GB
Preparing food
WARNING! Risk of material
damage!
Thick or firm peels, (e.g. of citrus fruits, pine-
apple), stems and pips of stone fruits (e.g.
cherries, peaches, apricots) must be removed
before blending.
• Rinse or wash the fruits.
• Cut the fruit into rough pieces (approx.
3-4 cm edge length).
• Please use a sufficient amount of liquid
(mineral water, fruit juice, milk, yoghurt).
We recommend a mixing ratio of 1:1.
Blending
CAUTION: depending on the hardness
and consistency of the ingredients in the
blender jug|6, do not fill it to the maximum;
otherwise the blade assembly|4 could be-
come clogged.
NOTES:
• If the smoothie is too thick, add a little
mineral water, fruit juice, milk or yo-
ghurt to suit your taste.
• You may achieve a more even consisten-
cy for the smoothie (e. g. when using
harder fruits), if you repeatedly interrupt
and restart the blending process (pulse
function: release and then press the mix
button|2 again).
• If there are still bit of food (e.g. fruit
cores) on the sealing ring|14, wipe it
down with kitchen roll in order to ensure
its sealing function.
1. Place the fruit pieces and other ingredi-
ents into the blender jug|6 as desired.
2. Figure C: stick the blender jug into the
preassembled blade assembly|4 from
the bottom. The marking|9 points to-
wards the opened lock|5. The locking
blades|10 on the blender jug engage
into the recess at the blade insert.