Victron energy MultiPlus 12/3000/120 Anleitung Seite 21

Stand-alone operation
Step 1: Setting ds2 and ds1 for stand-alone operation
DS-8 AC input Set as desired
DS-7 AC input Set as desired
DS-6 AC input Set as desired
DS-5 AES Set as desired
DS-4 Charging current Set as desired
DS-3 Charging current Set as desired
DS-2 Stand-alone operation
DS-1 Stand-alone operation
Examples of DIP sw itch settings for stand-alone mode are given below .
Example 1 show s the factory setting (since factory settings are entered by computer, all DIP sw itches of a new product are set to 'off'
and do not reflect the actual settings in the microprocessor.).
Four exam ples of stand-alone settings:
DS-8 AC input on
DS-7 AC input on
DS-6 AC input on
DS-5 AES of f
DS-4 Ch. current on
DS-3 Ch. current of f
DS-2 St.-alone mode of f
DS-1 St.-alone mode of f
Step1, stand-alone Step1, stand-alone
Example 1 (factory setting): Example 2:
8, 7, 6 AC-in: 50A* 8, 7, 6 AC-in: 50A*
5 AES: of f 5 AES: of f
4, 3 Charging current: 75% 4, 3 Charge: 100%
2, 1 Stand-alone mode 2, 1 Stand-alone
*Maximum is limited to 16A in case of models w ith 16A transfer switch
To store the settings after the required values have been set: press the 'Up' button for 2 seconds (upper button to the right of the DIP
sw itches, see appendix A, position J). The overload and low-battery LED's w ill flash to indicate acceptance of the settings.
We recommend making a note of the settings, and filing this information in a safe place.
The DIP sw itches can now be used to apply the remaining settings (step 2).
of f
of f
DS-8 on DS-8
DS-7 on DS-7 on
DS-6 on DS-6 on
DS-5 of f DS-5
DS-4 on DS-4 on
DS-3 on DS-3 on
DS-2 of f DS-2
DS-1 of f DS-1
Step1, stand-alone
Example 3:
8, 7, 6 AC-in: 16A
5 AES: of f
4, 3 Charge: 100%
2, 1 Stand-alone
of f DS-8 on
DS-7 on
DS-6 of f
of f DS-5 on
DS-4 of f
DS-3 on
of f DS-2 of f
of f DS-1 of f
Step1, stand-alone
Example 4:
8, 7, 6 AC-in: 30A*
5 AES: on
4, 3 Charge: 50%
2, 1 Stand-alone
17