Cembre HT131-C Bedienungsanleitung Seite 5

Die replacement
2.6)
To replace dies operate as follows:
– Upper die (91)
Take the die off its guide by pushing the die/head release pin (32).
Insert replacement die until secured by the die retaining pin (34).
– Lower die (90)
Take the die off its guide by pushing the die/ram release pin (38).
To facilitate this operation an advancement of 15÷20 mm (0.59-0.79 in.) of the ram (28) is sug-
gested.
Insert the new die in its guide till die/ram retainer pin (39) will hold it properly.
3. WARNING
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance of the tool.
3.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth, taking care to remove any residue,
especially close to pivots and moveable parts.
3.2) Storage
(Ref. to Fig. 3)
When not in use, the tool should be stored and transported in the plastic case, to prevent damage.
These plastic case (Type VAL-P3) is dimensioned 620x380xh135 mm (24.4x14.9x5.3 in.) and weights
2,5 kg (5.5 lbs).
3.3) Head rotation
For ease of operation, the tool head can rotate through 180°.
Warning: do not attempt to turn the head if the hydraulic circuit is pressurised.
5
(Ref. to Fig. 2)
ENGLISH