Gastroback Design Vakuumierer Advanced Scale Pro Bedienungsanleitung Seite 83

Problem
After unplugging the
appliance, the LCD dis-
play is still lit.
The LCD display shows
"o_Ld".
The scale does not show
any constant readings.
The scale platform is
empty but the scale
does not show zero.
Possible Reasons
It will take some
seconds until the LCD
display gets dark.
To much load on the
scale platform.
The appliance is not
standing level or wobb-
ling.
The lid of the appliance
is not closed properly.
The scale platform is not
installed correctly.
A lot of moisture/sol-
vent is evaporating duri-
ng weighing.
The scale sensor is
damaged.
You have entered cali-
bration mode. On the
LCD display "2000,0 g"
flashes.
The appliance is not
standing level or wobb-
ling.
The TARE function is
active.
The Easy Solution
This is normal. Wait some seconds.
Immediately remove all objects from the scale plat-
form.
Do not place more than 2kg ("2000,0g") on the scale plat-
form, including all vessels, containers and ingredients you use
for weighing.
For operation, always place the appliance on a stable and
level surface, where it will not tilt or wobble.
For weighting, ensure that the lid of the appliance is closed
completely. If required, touch the contact bar to close the lid.
Ensure to screw on the scale platform until a slight resistance
is felt. The scale platform may not wobble (see: 'Preparing
the Scale for Operation').
Use appropriate vessels closed properly for weighing warm
and/or highly alcoholic food and any items with high content
of solvents.
Leave hot food cool down before weighing.
Do not immerse the scale platform in any liquids. Always
immediately wipe off spilled liquids. Leave the scale platform
dry naturally for at least 1 day, if any liquids may have got
between the metal top plate and the plastic base of the scale
platform.
Contact your vendor for examination and repair.
IMMEDIATELY press the STOP button to cancel the
process. Always observe the instructions given in the
section 'Calibration', before using this feature.
For operation, always place the appliance on a stable and
level surface, where it will not tilt or wobble.
Press the TARE button to reset the scale to zero.
83