Specifications; Safety Instructions - Makita 9047 Betriebsanleitung

ENGLISH
1 Wheel guard
2 Screw
3 Notch
4 Side grip
5 Lock nut

SPECIFICATIONS

Model
Depressed center wheel diameter ............ 180 mm
Spindle thread ........................................... M14
–1
No load speed (min ) .............................. 8,500
Overall length ............................................ 470mm
Net weight ................................................. 4.8 kg
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
They are double-insulated in accordance with Euro-
pean Standard and can, therefore, also be used from
sockets without earth wire.
For models 9047, 9049, 9057 and 9059, public
low-voltage distribution systems of between
220 V and 250 V
Switching operations of electric apparatus cause volt-
age fluctuations. The operation of this device under
unfavorable mains conditions can have adverse
effects to the operation of other equipment. With a
mains impedance equal or less than 0.22 (for 9047
and 9049) / 0.24 (for 9057 and 9059) Ohms it can be
presumed that there will be no negative effects.
The mains socket used for this device must be pro-
tected with a fuse or protective circuit breaker having
slow tripping characteristics.
4
Explanation of general view
6 Depressed center wheel
7 Inner flange
8 Super flange
9 Lock nut wrench
10 Shaft lock
9047/9047S
9047F/9047SF 9057F/9057SF 9049F/9049SF 9059F/9059SF

SAFETY INSTRUCTIONS

Warning! When using electric tools, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock and personal injury,
including the following. Read all these instruc-
tions before attempting to operate this product
and save these instructions.
For safe operation:
1.
2.
3.
4.
5.
6.
7.
8.
11 Switch trigger
12 Lock lever
13 Brush holder cap
14 Screwdriver
9057/9057S 9049/9049S
180 mm 230 mm
M14 M14
8,500 6,600
470mm 470mm
5.1kg 4.8 kg
Keep work area clean
Cluttered areas and benches invite injuries.
Consider work area environment
Don't expose power tools to rain. Don't use
power tools in damp or wet locations. Keep work
area well lit. Don't use power tools in presence of
flammable liquids or gases.
Guard against electric shock
Prevent body contact with grounded surfaces
(e.g. pipes, radiators, ranges, refrigerators).
Keep children away
Do not let visitors contact tool or extension cord.
All visitors should be kept away from work area.
Store idle tools
When not in use, tools should be stored in dry,
high, or locked-up place, out of the reach of chil-
dren.
Don't force tool
It will do the job better and safer at the rate for
which it was intended.
Use right tool
Don't force small tools or attachments to do the
job of a heavy duty tool. Don't use tools for pur-
poses not intended; for example, don't use circu-
lar saw for cutting tree limbs or logs.
Dress properly
Do not wear loose clothing or jewelry. They can
be caught in moving parts. Rubber gloves and
non-skid footwear are recommended when work-
ing outdoors. Wear protective hair covering to
contain long hair.
9059/9059S
230 mm
M14
6,600
470mm
5.1 kg