Maintenance - Rema Tip Top PROMAXX 8200 Betriebsanleitung

MAINTENANCE

WARNING
The manufacturer declines all liability
for claims deriving from the use of non-
original spares or accessories.
WARNING
It is expressly forbidden to attempt to
alter operating pressure of the relief
valves or the pressure regulator.
The manufacturer declines all liability
for damage resulting from tampering
with these components.
WARNING
Before making any adjustments or
carrying out maintenance, disconnect
the electrical supply from the machine
and make sure that all moving parts are
suitable immobilised.
WARNING
Do not remove or modify any parts of this
machine except in the case of service
interventions.
DANGER
When the machine is disconnected from
the air system, the devices bearing the
above plate may remain pressurized.
The FRL unit (filter, regulator and lu-
bricator) is installed to filter the air,
regulate its pressure and lubricate it.
The FRL unit withstands a maximum
input pressure of 18 bar and has a re-
gulation range from 0.5 to 10 bar. The
setting can be modified by pulling the
knob to the OUT position and turning
it; after adjusting, return the knob to
the locked position by pushing it down
(fig.25a).
The lubricating flow-rate is adjusted by
turning the screw on the element "L",
(fig.25b); normally the unit is preset
38
at a pressure of 10 Bar, with lubricant
having viscosity SAE20, so that one drop
of lubricant is dispensed every 4 times
the bead-breaker is operated (check
through the transparent cup).
DANGER
Before carrying out any maintenance
operation or topping up with lubricant,
disconnect the machine from the com-
pressed air supply line.
Check the lubricant level periodically
through the windows provided and top
up as shown in fig.25c. Top up only with
SAE20 non detergent oil to a total quan-
tity of 50 cc.
The FR filter regulator unit is equipped
with an automatic system for drainage
of the condensation water, so in normal
conditions it does not require any parti-
cular maintenance. However, the water
may be drained by hand at any time
(fig.25d) even with the machine connected
to the compressed air supply. However,
the condensation water will be drained
whenever the compressed air supply is
disconnected.
Normally it is not necessary to remove
the cups, but this may be necessary after
long periods out of use; if the cup cannot
be removed with the hands only, use the
spanner provided (fig.25e).
Clean with dry cloth. Avoid contact with
solvents
ATTENTION
Keep the work area clean.
Do not clean the machine with compres-
sed air or jets of water.
When cleaning the area avoid raising
dust as far as possible.
e - Operator manual
nglIsh