Safety Regulations - Rema Tip Top PROMAXX 8200 Betriebsanleitung

compressed air supply line must provide a
pressure range from a minimum of 8 bar
to a maximum of 16 bar.
NOTE
The machine is equipped with a pressure
regulator set at 10 bar (standard machine
operation). If you are working with easily
deformable rims (motor cycle wheels for
example) we recommend lowering the
pressure temporarily to 7 or 8 bar.
ATTENTION
For correct and safe operation of the
machine it must be connected to an
efficient grounding circuit.
NEVER connect the ground wire to a
gas pipe, water pipe, telephone line or
other makeshift system.
WARNING
Any connections to the workshop
electrical panel are the customer's
responsibility, and must be made by
staff qualified in accordance with the
relevant legal requirements.
Before making the electrical and pneuma-
tic hook-ups, make sure that the machine
is configured as described below (fig.5):
- pedals A in the "fully down" position and
B in the "fully up" position;
- tower C vertical (not tilted).

SAFETY REGULATIONS

The equipment is intended for professional
use only.
WARNING
Only one operator may work on the
equipment at a time.
WARNING
Failure to observe these instructions
and the relative danger warnings can
cause serious injury to the operator and
others. Do not power up the machine
e - Operator manual
nglIsh
before you have read and understood
all the danger/warning/attention notices
in this manual.
This machine must be used only by
qualified and authorised personnel.
A qualified operator is construed as a
person who has read and understood
the manufacturer's instructions, is sui-
tably trained, and is conversant with
safety and adjustment procedures to be
adhered to during operations. Operators
are expressly forbidden from using the
machine under the influence of alcohol
or drugs capable of affecting physical
and mental capacity.
The following conditions are essential:
- The operator must be able to read and
understand all the information in this
manual.
- Make sure you have a thorough know-
ledge of the capabilities and characte-
ristics of this machine.
- Keep unauthorised persons well clear
of the area of operations.
- Make sure that the machine has been in-
stalled in compliance with established
legislation and standards.
- Make sure that all machine operators
are suitable trained, that they are capa-
ble of using the machine correctly and
that they are adequately supervised
during their work.
- Never leave nuts, bolts, tools or other
equipment on the machine to avoid the
risk that they could become entrapped
between moving parts during work.
- Do not touch power lines or the inside
of electric motors or other electrical
equipment until the power has been
disconnected and locked out.
- Read this manual carefully and learn how
to use the machine correctly and safely.
- Always keep this user manual in a pla-
ce where it can be readily consulted
when working with the machine and
consult it whenever you are in need
of confirmation or explanations.
27