Inflation - Rema Tip Top PROMAXX 8200 Betriebsanleitung

bead, repeat the same steps for the
upper bead (fig.21).
- Tilt the tower back, free the wheel and
take it off the tyre changer.
Special tools
To facilitate mounting/demounting of low-
profile tyres, it is advisable to use the bead
presser pliers (optional accessory).

INFLATION

WARNING
Tyre inflation is a dangerous operation.
Always inflate tyres in the strictest ob-
servance of the following instructions.
ATTENTION
During this stage of operations noise
levels of 85 dB(A) may be present. We
recommend that the operator wears
hearing protectors.
WARNING
During the bead insertion and inflation
procedure, safety goggles and ear de-
fenders must be worn.
DANGER
The machine, even if it limits pressure,
does not provide sufficient protection
against exploding tyres during infla-
tion.
Failure to observe the following instruc-
tions will make tyre inflation extremely
dangerous.
DANGER
USERS MUST ABSOLUTELY NEVER exceed
the pressure recommended by the
tyre manufacturer. Tyres may explode
if inflated beyond these limits or the
structures may incur serious damage
not visible at the time. KEEP THE HANDS
AND BODY WELL CLEAR OF THE TYRE
e - Operator manual
nglIsh
DURING INFLATION. Make sure you are
well concentrated during this stage of
operations and make frequent checks
on the tyre pressure to avoid the risk
of excess inflation. Exploding tyres can
cause serious injury or death.
Inflation
(only PROMAXX 8240)
The machine is equipped with a tyre in-
flation pedal and a pressure gauge for
reading the tyre pressure.
- Release the wheel from the sliding
clamps on the table top.
- Bring the horizontal arm to the fully
extended position.
- Lower the vertical rod until it touches
the rim.
- Lock the horizontal arm and the vertical
rod in the positions described above
fig.26.
- Connect the Doyfe inflation chuck (21)
on the air hose to the valve stem.
Inflate the tyre by pressing the pedal
briefly and repeatedly; check the pres-
sure gauge frequently to make sure
that the pressure NEVER exceeds the
maximum pressure specified by the tyre
manufacturer.
Inflation (solo PROMAXX 8200)
- Release the wheel from the sliding
clamps on the table top.
- Bring the horizontal arm to the fully
extended position.
- Lower the vertical rod until it touches
the rim.
- Lock the horizontal arm and the vertical
rod in the positions described above
fig.26.
- Connect the Doyfe inflation chuck (21)
on the air hose to the valve stem.
Inflate the tyre by operating the gun briefly
and repeatedly; check the pressure gauge
frequently to make sure that the pressure
NEVER exceeds the maximum pressure
specified by the tyre manufacturer.
35