Air Filter; Starting - Manual - Texas TG500A Bedienungsanleitung

5. Air filter

Please inspect and clean the air filter on a regular basis. If the filter has not been cleaned
for a longer period, this will be noticed on the engine's power take-off and the exhaustion.
1. Dismount the knurled nut (1), which fastens the cover (2) to the air filter and
remove the cover.
2. Clean easily around the air filter before it is removed.
3. Remove the filter carefully and inspect it. Make sure no dirt gets in the
carburettor.
4. Clean the foam element in gasoline or petroleum.
5. Squeeze the element and let it dry. Wet the element in new oil and squeeze out
the extra oil.
6. Clean the filter holder (3).
7. Add the new oil up to the oil level mark (4) using the same type of oil used for
the engine.
8. Put the element back in its place.
9. Draw attention to all parts being assembled correctly.
If you are in doubt that the air filter is mounted correctly, please contact your Power Line

6. Starting - Manual

1. Open the fuel tap.
2. Turn the choke to the right, if the engine is already warm it is not necessary to use the
choke.
3. Turn the engine's gas control completely to the left, thereby full gas is applied.
4. (If the engine is mounted on a machine with cable-regulated gas, full gas is given).
5. Turn the machines ignition switch to the "ON" position.
6. Pull the engine's starting cord slowly until you feel resistance. Thereafter pull in one
long draw. Never let the starting cord run back by itself, always follow it with your hand.
7. Regulate the choker until the engine is running evenly.
See figures 1, 2, 4, 5, 6 on page 3.
AIR FILTER
QUESTION
dealer.
PROCEDURE
13