Battery Maintenance - Upright SL20 Betriebsanleitung

M
AINTENANCE
Never perform service in the elevating assembly area while the platform is
elevated without first blocking the elevating assembly.
DO NOT stand in elevating assembly area while deploying or storing brace.
DO NOT block elevating assembly with a load on the platform.
B
B
Hazard of explosive gas mixture. Keep sparks, flame, and smoking material
away from battery.
Always wear safety glasses when working near batteries.
Battery fluid is highly corrosive. Thoroughly rinse away any spilled fluid with
clean water.
Always replace batteries with UpRight batteries or manufacturer approved
replacements weighing 28.1 kg (62 lbs.) each.
8
W A R N I N G
!
T E
LOCKING HE LEVATING
B I
RACE NSTALLATION
1. Park the work platform on firm, level
surface.
2. Turn and hold the Chassis Key Switch to
Chassis. Push the Lift/Lower Switch to LIFT
and elevate the platform approximately two
feet.
3. Place a 10 cm x 10 cm (4 inch x 4 inch)
wood block as shown in Figure 6.
4. Turn and hold the Chassis Key Switch to
CHASSIS. Push Chassis Lift Switch to
LOWER and gradually lower the platform
until the elevating assembly is supported by
the wood block.
B R
RACE EMOVAL
1. Turn and hold the Chassis Key Switch to
Chassis. Push the Lift/Lower Switch to LIFT
and gradually raise the platform until the wood block can be removed.
2. Remove the wood block.
3. Turn and hold the Chassis Key Switch to CHASSIS. Push the Lift/Lower Switch to LOWER
and completely lower platform.
M
ATTERY AINTENANCE
W A R N I N G
!
• Check the battery fluid levels daily, especially if the work platform is being used in a warm,
dry climate.
• If the electrolyte level is lower than 10 mm (
Do not use tap water with high mineral content, as it will shorten battery life.
• The battery and cables should be inspected regularly for signs of cracks in the case, electro-
lyte leakage and corrosion of the terminals. Inspect cables for worn spots or breaks in the
insulation and for broken cable terminals. Keep terminals and tops of batteries clean.
• Refer to the Service Manual to extend battery life and for complete service instructions.
!
A
SSEMBLY
Figure 6: Blocking the Elevating Assembly
Wood Block
!
in.) above the plates, add distilled water ONLY.
3
/
8
SL20