Troubleshooting; Malfunction Causes And Remedies - Silvercrest KH 2131 Bedienungsanleitung

Troubleshooting

GB
IE

Malfunction causes and remedies

Defect
No audio/video
transmission
Poor transfer quality
Disruptions in
remote control
commands
12
WARNING
► Repairs to electronic devices may only be carried out by specialists who
have been trained by the manufacturer. Considerable danger to the con-
sumer and damage to the device can occur as a result of incorrect repairs.
Possible cause
The transmitter or receiver
is not switched on.
The signal source
(e.g. DVD player) is
not switched on
The transmitter and receiver
are not adjusted to the
same channel.
The transmitter or receiver
are not connected properly.
The transmission range is
reduced because of thick
walls or ceilings.
The transmitter and receiver
are not aligned with each
other.
There are possibly other
radio devices in use on
the same frequency.
The infrared transmitting
diode blocks the signal
source of the infrared
receiver.
NOTICE
► If you cannot solve the problem with the aforementioned methods, please
contact Customer Service.
Troubleshooting
Solution
Switch the transmitter or receiver on
with the On/Off switch
Switch the signal source on and,
if necessary, start playback.
Select the same channel on the trans-
mitter and receiver with the channel
selector switch resp.
5
Check the Cinch and AV connections
on the connected devices as well as
on the transmitter and the receiver.
Reduce the distance between the
transmitter and the receiver.
Change the alignment of the
transmitting antenna
Change the channel setting on the
transmitter and receiver. Ensure that
the transmitter and the receiver have
the same channel setting.
Affi x the infrared transmitting diode
slightly off set to the signal source of
the infrared receiver.
resp. .
2
14
.
17
resp. .
13
KH 2131