Disposal Of The Packaging; Requirements On The Installation Location; Electrical Connections - Silvercrest KH 2131 Bedienungsanleitung

Setting up and connecting

Disposal of the packaging

The packaging protects the device from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material
and reduces generated waste. Dispose of packaging material that is no longer
needed according to the regionally established regulations.
NOTICE
► If possible preserve the device's original packaging during the warranty
period so that in the case of a warranty claim you can package the device
properly for return.

Requirements on the Installation Location

For the safe and error-free operation of the device, the installation location must
fulfi ll the following conditions:
■ Place the device on a fi rm, fl at and level surface.
■ Do not locate the device in a hot, wet or very humid environment or close to
fl ammable material.
■ The surfaces of furniture may contain components that could attack and
weaken the rubber pads of the device. If necessary, place an anti-slip mat or
similar under the rubber pads of the device.
■ The mains power socket must at all times be easily accessible, so that the
power adapter can be easily and quickly removed if necessary.

Electrical connections

■ Before connecting up, compare the connection data (voltage and frequency)
on the type plate of the device with that of your power supply network.
This data must tally in order to avoid damage to the device.
■ Check to ensure that the power cable of the device is undamaged and that it
will not be laid over hot surfaces and/or sharp edges.
■ Ensure that the power cable is not over taut or crimped/folded.
■ Do not let the power cable hang over edges (trip wire eff ect).
NOTICE
► It is recommended that, in addition to switching the radio transmission set
off , you disconnect the power adapter from the mains power supply or
use switchable power strips. Only in this way can it be ensured that the
device is fully switched off and a contribution made to the economical use
of power.
KH 2131
GB
IE
7