Baking Crêpes - Silvercrest SCM 1400 A1 Bedienungsanleitung

Baking crêpes
1. Insert the power plug 2 into a wall socket.
The control lamp 8 glows.
2. Place the thermostat 7 at the desired heating
level. The higher the temperature level, the darker
the crêpes. Wait until the green control lamp
"Ready" 9 glows. This indicates that the appli-
ance is heated up.
3. Place a scoop full of pastry onto the baking
plate 1.
Note:
You can determine the browning of the crêpe with
the help of the thermostat 7 or with the baking
time.
Note:
To determine the correct volume of pastry, put as
much pastry onto the baking plate 1 as is required
to cover it to about 2/3 of its area. Make certain
that the pastry does not run over the edge of the
baking plate 1 surface. As required, reduce or in-
crease the volume of pastry for the next crêpe.
4. Briefly dip the pastry spreader 6 in water.
5. Using the pastry spreader 6, evenly spread
the pastry over the baking plate 1:
Place the pastry spreader 6 without pressure
onto the pastry and then spread it in a circle
from the center of the baking plate 1 to the
edge. The pastry should only be spread thinly
over the baking plate 1.
6. After about 45 seconds (depending on the
desired degree of browning), turn the pastry
with the help of the crêpe turner 5.
Note:
After every use, dip the pastry spreader 6 in water.
This allows the pastry to be better spread.
Note:
It could happen that, during baking, the green
control lamp "Ready" 9 briefly extinguishes itself
and then glows once again. This indicates that the
set temperature had fallen and the appliance had
heated itself back up.
Note:
The given baking times are only guidlines. The
baking time of a crêpe can, subject to taste, vary.
Discover the optimal baking time through trial and
error.
7. After a further 45 seconds, using the crêpe
turner 5 take the crêpe from the baking plate 1:
For this, slide the crêpe turner 5 under the crêpe
and lift it off. Place it on a plate.
8. You can now garnish the crêpe according to taste.
CAUTION! Appliance Damage!
• Do not coat or decorate the crêpe when it is on
the baking plate 1.
• Do not cut the crêpe when it is on the baking
plate 1.
• Do not use sharp or metallic utensils to turn the
crêpe or to lift it from the baking plate 1.
This could cause irreparable damage to the baking
plate 1!
9. Repeat the process for further crêpes.
- 12 -