Ugolini HT 10 Gebrauchsanweisung Seite 14

HT 10/11/20
5. 3. 5 ASSEMBLY
1 Slide drip tray with its cover into place.
2 See 5.3.6 FAUCET ASSEMBLY paragraph
3 Fit bowl gasket to the bowl leaving the thickest part of it out-
side the bowl (see figure 9).
4 Place bowl on the unit, with gasket around the cooling
dome, then push it down all the way.
Wet cooling dome and gasket for ease of insertion.
5 HT11 - HT20 PS lines: raessemble pump assembly; place
it into bowl location and turn it counterclockwise until it stops
into position.
6 HT10 - HT20M lines: replace stirrer onto its shaft and drop
it into place freely.
5. 3. 6 FAUCET ASSEMBLY
5. 3. 6. 1 HT11 - HT20 LINES WITH PINCH
TUBE FAUCET
1 Fit the faucet cover and the faucet body by reversing disas-
sembly operations (see figure 5).
2 Push (1) the dispensing handle and insert (2) the pinch tube
into its vertical seat in the bowl bottom (see figure 10).
figure 10
3 Lightly pull (3) the pinch tube end downwards till it is well
arranged. (see figure 11).
figure 11
figure 9
5. 3. 6. 2 HT11 - HT20 LINES WITH GRAVITY
FAUCET
1 Fit the faucet body by reversing disassembly operations
(see figure 7).
2 Install the faucet handle (1-2) and the piston with its gasket
(3) (see figure 12).
5. 3. 6. 3 HT10 LINE
1 Fit the faucet cover and the faucet body by reversing disas-
sembly operations (vedere figure 5).
2 Insert the pinch tube into its horizontal seat in the bowl
bottom (see figure 13).
3 Insert the pinch tube end into the faucet body vertical seat
(see figure 14).
4 Push (1) the dispensing handle and pull the pinch tube end
14
figure 12
figure 13
figure 14