Package, Transport, Storage; Delivery; Transport; Storage - Homa C80 Originalbetriebsanleitung

3.3.2. Motor
The motor consists of a stator and the motor shaft with
the impeller assembly. The line for the power supply is
designed for maximum mechanical performance accord-
ing to the characteristic line or the pump type plate. The
cable entry points and lines are water tight sealed from
the pumped medium.
General Motor Data
Operating mode with submerged motor
Medium temperature:
Insulation class
Protection type
Standard cable length
Voltage
Warning of rotating impeller!
Do not touch the rotating impeller or reach through
the pressure socket into the pump chamber!During
operation, never reach into the pump chamber or the
rotating parts. Before maintenance or repair work,
switch off the machine and allow the rotating parts
come to a halt!
Motor cooling
The cooling jacket with the overhead pressure connection
provides sufficient motor cooling even in sipping mode.
3.3.3. Impeller
The impeller is mounted on the motor shaft and is dri-
ven by it. The impeller is a multi-vane impeller, for tainted
fluids with fixed solids up to 1 mm with the C80W and up
to 8 mm with the C135W.
20 | EngliSH
S1
35°C
B
IP68
10 m
230V / 1Ph / 50Hz

4. Package, Transport, Storage

4.1. Delivery

On arrival, the delivered items must be inspected for dam-
age and a check made that all parts are present. If any
parts are damaged or missing, the transport company or
the manufacturer must be informed on the day of delivery.
Any claim made at a later date will be deemed invalid.
Damage to parts must be noted on the delivery or freight
documentation.

4.2. Transport

The product is delivered by the manufacturer/shipping
agency in suitable packaging. This normally precludes
the possibility of damage occurring during transport and
storage. The packaging should be stored in a safe place if
the location used is changed frequently.

4.3. Storage

Newly supplied products are prepared that they can
be stored for at 1 year. The product should be cleaned
thoroughly before interim storage.
The following should be taken into consideration for
storage:
• Place the product on a firm surface and secure it
against falling over.
• We recommend a dry, frost-protected room with a
temperature of between 5 °C and 25 °C for storage.
• The machine must be protected from direct sunlight,
heat, dust, and frost.
• If the product has been stored for a long period of
time it should be cleaned of impurities such as dust
and oil deposits before start-up
If these rules are observed, your product can be stored
for a longer period. Please remember that elastomer parts
and coatings become brittle naturally. If the product is
to be stored for longer than 6 months, we recommend
checking these parts and replacing them as necessary.
Please consult the manufacturer.

4.4. Returning to the supplier

Products which are delivered to the plant must be
clean and correctly packaged. In this context, clean
means that impurities
decontaminated if it has been used with materials which are
hazardous to health. The packaging must protect the product
against damage. Please contact the manufacturer before
returning!
have been removed and