Main Board Layout - SystemAir SAVE VSR 500 Betriebs- Und Wartungsanleitung

GB
7.1

Main board layout

The SAVE VSR 300/500 is equipped with built-in regulation and internal wiring.
The figure shows the main circuit board. See wiring diagram for more information.
Position
MB
CB
1
2
3
4
5
6
7
8
9
10
11
12
13
14
211458 | A004
Fig. 4 Main circuit board connections
Description
Main circuit board
Connection to the external connection box
Terminals for a heater
Terminals for a TRIAC
Terminals for the mains power supply
Terminals for power supply of extract air fan
Terminals for power supply of supply air fan
Terminals for internal relative humidity/temperature sensor
Analog input 1 — Outdoor air sensor
Analog input 2 — Supply air sensor
Analog input 3 — Freely configurable
Analog input 4 — Freely configurable / Overheat temperature sensor (units with
heater)
Analog input 5 — Freely configurable
Digital input 1 — Rotor guard sensor (VSR, VTR units)/ Damper signal (VTC units)
Digital input 2 — Freely configurable / Cooker hood (VTR 150/K unit)
Analog output 2 — Freely configurable / Electrical heater controller (VTC 700 unit)
Electrical connections |
13