Weighing Function; Troubleshooting Guide - Kenwood FHM15 Bedienungsanleitungen

recipes ideas/suggestions
carrot and coriander soup
use the blender
25g butter
50g onion chopped
1 clove garlic crushed
750g carrot cut into 1½ cm cubes
cold chicken stock
10-15mls (2-3tsp) ground coriander
salt and pepper
Problem
The processor will not operate.
Blender will not operate.
Processor stops or slows during
processing.

Weighing function

(----) flashing on screen.
Weight changed on display screen.
Processor not operating and speed
light flashing.
Blender leaking from blade assembly
base.
Blender seal missing from blade unit
when removed from packaging.
Poor performance of tools/
attachments.

troubleshooting guide

Cause
No Power.
Speed light not lit.
Bowl not fitted to power unit correctly.
Bowl lid not locked on correctly.
Blender not locked on correctly.
Blender not assembled correctly.
Overload protection operated.
Processor overloaded or overheated during
operation.
Maximum capacity exceeded.
Either the ingredients or the bowl/attachment/
lid have been removed and (- - - -) represents
a minus reading.
Quantity weighed too small.
Power unit moved during operation.
Appliance left plugged in without operating
for more than 30 minutes.
Lid or bowl removed or unlocked whilst
speed selected.
Seal missing.
Seal incorrectly fitted.
Seal damaged.
The seal is packed pre-fitted to the blade
unit.
Refer to hints in relevant "using the attachment" section. Check attachments are assembled
correctly.
11
1 Melt the butter in a pan, add the onion and garlic and fry
until soft.
2 Place the carrot into the blender, add the onion and garlic.
Add sufficient stock to reach the 1.6L level marked on the
goblet. Fit the lid and filler cap.
3 Blend on maximum speed for 5 seconds for a coarse soup
or longer for a finer result.
4 Transfer the mixture to a saucepan, add the coriander and
seasoning and simmer the soup for 30 to 35 minutes or until
cooked.
5 Adjust the seasoning as necessary and add extra liquid if
required.
Solution
Check processor is plugged in.
Check bowl is located correctly and the
handle is situated towards the right hand
side.
Check that the lid interlock is located
correctly into the handle area.
The processor will not work if the bowl and
lid are fitted incorrectly.
The blender will not operate if fitted
incorrectly to the interlock.
Check blade unit is fully tightened into the
goblet.
Switch off, unplug and allow the appliance
to cool down for approximately 15 minutes.
Refer to the speed chart for maximum
capacities to process.
Press the ZERO button to reset.
Use teaspoon and tablespoon measures
for very small quantities.
Do not move unit during use.
Zero the display before weighing next
ingredients.
Press either the ZERO button or turn the
speed control OFF 'O' and then back to
the 'ON' position.
To reset – turn to 'O', then turn to 'ON'
and reselect a speed.
Check seal is fitted correctly and not
damaged. To obtain a replacement seal
see "service & customer care".
Unscrew goblet and check that seal is
fitted to blade unit.
To obtain a replacement seal see "service
& customer care".