Herunterladen Inhalt Inhalt Diese Seite drucken

Sensor Links; Sensor Left - Moller Hi-R 1000 Serviceanleitung

Inhaltsverzeichnis

Werbung

5.17 Sensor links

Achtung! Vor Öffnen des Geräts System
ausschalten und Netzstecker ziehen.
! Deckel (1-6) öffnen.
! Den Handschalter mit den 3 Befestigungs-
schrauben (11-4) vom Sensor abschrauben.
! Die Befestigungsschrauben (11-6) der
Verteilerleiterplatte (11-1) herausdrehen.
! Die Verteilerleiterplatte (11-1) anheben.
! Den Stecker von der Verteilerleiterplatte (A4-X8)
abziehen.
! Der Stecker des Sensors wird entsprechend
abgewinkelt, dass er durch das Mikroskop-
gehäuse geschoben werden kann.
! Den Sensor mit der Befestigungsplatte (2-2) vom
Gehäuse abschrauben.
! Die Befestigungsplatte vom alten Sensor
abschrauben, in gleicher Lage an den neuen
Sensor anschrauben. Mit Loctite sichern.
! Beim Montieren des neuen Sensors ist auf die
Lage zu achten. Die rote Markierung zeigt nach
oben!
! Der Einbau erfolgt in umgekehrter Reihenfolge.
! Schrauben (2-2) und (11-4) mit Loctite sichern,
dabei nicht die Kunststoffschelle berühren.
! Die Steckverbinder werden mithilfe des
Verdrahtungsplans 656 950 Sch wieder
aufgesteckt.
! Funktionstest durchführen.
2-1
36

5.17 Sensor left

Attention! Prior to open the equipment,switch
off the system and pull off the mains plug.
! Open the cover (1-6).
! Remove the handle with 3 fixing screws (11-4)
from the sensor.
! Remove the fixing screws (11-6) from the
distribution PCB (11-1).
! Lift the distribution PCB (11-1).
! Pull off the plug from the distribution PCB (A4-
X8).
! The plug of the sensor has to be inclined in
order to shift it through the microscope
housing.
! Unscrew the sensor with the fixing plate (2-2)
from the housing.
! Detach the fixing plate from the old sensor.
Mount it to the new sensor in the same postion,
secure with Loctite.
! When installing the new sensor, pay attention
to its position. The red marking shows
upwards!
! The installation is performed vice versa.
! Secure the screws (2-2) and (11-4) with Loctite.
Do not touch the plastic clip.
! The plug connectors are slipped on again
following the wiring plan 656 950 Sch.
! Perform the function test.
X8
X9
2-2
11-4
X11 X14
11-1
11-6
11-2
11-3
656 952 a
11-5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis